Canon Staple Finisher-R1 Service Manual page 23

2
Technology > Processing Tray Unit > Alignment / Shifting Operation
The relationship between operation modes and alignment positions is summarized in the
following table:
Operation Mode Paper Width
Non-Sort / Sort 180 mm or more
less than 180 mm
Staple 200 mm or more
less than 200 mm
2 Technology > Processing Tray Unit > Alignment / Shifting Operation
Alignment Position
• Front alignment position: 10 mm frontward
from the central reference position
• Rear alignment position: 10 mm backward
from the central reference position
Central reference position
Stapling position
10 mm frontward from the central reference
position
The relationship between operation modes and shifting positions is summarized in the
following table:
Operation Mode Paper Width
Non-Sort / Sort 210 mm or
more
180 mm or
more to less
than 210 mm
T-2-5
less than 180
mm
Staple 210 mm or
more
less than 210
mm
NOTE:
In the non-sort mode, paper is aligned/shifted at the position which is different from the
position where paper was aligned/shifted at the end of the previous copy job.
Shifting Position
• Front shift position: 10 mm frontward from the central
reference position (Same as the alignment position)
• Rear shift position 10 mm backward from the central
reference position (Same as the alignment position)
*: Shift amount: 20 mm
• Front shift position: F mm frontward from the central
reference position
F = 110 - ("Paper width" / 2)
• Rear shift position: R mm frontward from the central
reference position
R = 85 - ("Paper width" / 2)
*: Shift amount: 25 mm
• Front shift position: 10 mm frontward from the central
reference position
• Rear shift position: 10 mm backward from the central
reference position
*: Shift amount: 20 mm
• Front shift position: 10 mm frontward from the central
reference position
• Rear shift position: 10 mm backward from the central
reference position
*: Shift amount: 20 mm
• Front shift position: F mm frontward from the central
reference position
F = 110 - ("Paper width" / 2)
• Rear shift position: R mm frontward from the central
reference position
R = 85 - ("Paper width" / 2)
*: Shift amount: 25 mm
2-11
T-2-6
2-11