Setup; Preparing The Machine; Installing The Ce Kit; Installing The Debris Guard To The Front Axle - Toro 31971 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
No parts required
2
No parts required
Debris guard
3
Bracket
Rivet
Hex-head bolt
4
Washer
Height-of-cut pin
Shoulder bolt
5
Spacer
6
No parts required
7
No parts required
WARNING
If you leave the key in the switch, someone could accidentally start the engine and seriously
injure you or other bystanders.
Remove the key from the switch before you install the cutting unit
DANGER
If the engine is started and the PTO shaft is
allowed to rotate, serious injury could result.
Do not start the engine and engage the PTO
switch when the PTO shaft is not connected
to the gearbox on the cutting unit.
Note:
Determine the left and right sides of the
machine from the normal operating position.
1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface.
All manuals and user guides at all-guidesbox.com
Description
2.
3.

Installing the CE Kit

If Required (CE-Compliant
Countries Only)
No Parts Required
Procedure
If you use this machine in a country that complies
to CE standards, install the CE Kit; refer to the kit
Installation Instructions.
8
Qty.
–
Prepare the machine.
–
Install the CE kit (if required).
1
1 Install the debris guard to the front axle.
5
2
2 Install the cutting unit to the traction unit.
2
2
Install the PTO cover.
2
–
Level the cutting unit.
–
Grease the cutting unit.
Engage the parking brake.
Shut off the engine and remove the key.
2
Use