Sealey HT105LED.V3 Instructions

thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instructions
1. Safety
inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. if worn or
9
damaged do Not use.
ensure the torch is fully charged before initial use.
9
do Not charge in damp conditions.
8
do Not turn the torch on when it is being charged.
8
do Not shine directly into your, another person's or an animal's eyes.
8
do Not allow children to use the torch.
8
do Not handle or move the torch whilst it is being charged.
8
do Not use the torch if you suspect that the battery or the torch casing is damaged.
8
do Not leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
8
recharge the battery at least once every six months of non-use.
do Not attempt to open, disassemble, modify or service the battery pack.
8
do Not crush, puncture, short external contacts or dispose of in fire or water.
8
replace only with the battery pack designated for this product.
9
recycle or dispose of used battery as stipulated by local regulation.
9
if the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. if it gets in your eyes, rinse thoroughly with cool
9
water and seek immediate medical attention.
2. iNtroductioN
Hands-free cree XPe led spotlight with adjustable inclination to direct light as required. features three settings - full light, low light or
flashing. Adjustable headband and foam brow for added comfort. Powered by rechargeable Li-ion 3.7V 1.5Ah battery. Supplied with micro USB
charging lead.
3. SpecificatioN
model no ......................................................... HT105LED.V3
led ........................................................................3W CREE
lumen output .............................................................. 220lm
Battery ........................................................3.7V 1.5Ah Li-ion
operating time .............................3hr @ 100%, 10hr @ 30%
charging time .................................................................... 4h
4. operatioN
4.1. cHargiNg (fig.2)
4.1.1. remove usB socket cover on battery pack.
4.1.2. connect the usB lead to the port on the rear of the battery pack and a usB power socket. turn on the power supply.
4.1.3. the charging led on the lamp will light red to show that charging has commenced.
4.1.4. When the battery has fully charged the LED will turn GREEN.
4.1.5. switch off power supply, remove charging lead and replace socket cover on battery pack.
4.2. operatioN
4.2.1. Adjust the three straps to fit your head size.
4.2.2. To turn on press the red button on the back of the torch unit, once for 100%, twice 30% three times flashing and once more to turn off.
4.2.3. to switch on rear red light, with front light on hold down red button for 2 seconds, the rear red light will light up. to switch off, switch
off front light, rear light will default to off.
© Jack sealey limited
instructions for
Head torcH 3w cree led recHargeable
Ht105led.V3
model no:
Original Language Version HT105LED.V3 | Issue 1 13/04/17