Health O Meter HDM560 - Weight Tracking Scale Manual

KEYS AND ICONS

1. Weight Readout
2. Difference in weight compared to previously saved weight
3. Unit of Measure: Pounds (LB) or Kilograms (KG)
4. Memory indicator

FIRST TIME SETUP

Back of the Scale

1. Select pounds (LB) or kilograms (KG).
2. Always place the scale on a flat surface. A hard surface is best for maximum accuracy.

USING YOUR WEIGHT MONITORING SCALE

1. Press and hold the lower corner of the scale platform for a few seconds to activate the user feature.
   NOTE: Once a user number appears, tap the lower corner again to select a different user number if desired. This model will save readings for up to two (2) users.
2. The last weight from the desireduser will be displayed (First time use will display 0.0). Then the scale will calibrate "- - -", and will display "0.0" and either "LB" or "KG".
3. Step on the scale and position your feet in a manner that will distribute your weight evenly over the entire scale platform. Stand still while reading the display. Your weight will be displayed first, then the change from the previously saved reading.

CARING FOR YOUR SCALE

Periodically wipe the scale surface down with a DRY cloth to remove dust.

WEIGHING WITHOUT SELECTING A USER

1. Before each weigh press the lower corner of the scale platform to activate the scale. Then the scale will calibrate "- - -", and will display "0.0" with either "LB" or "KG".
2. Step on the scale and position your feet in a manner that will distribute your weight evenly over the entire scale platform. Stand still while reading the display.
3. Your scale will turn off automatically after a few seconds.

REPLACING THE BATTERIES

This unit includes ONE (1) CR2032 battery. When "LO" appears on the display, replace the battery.

Removing the battery will not affect the recorded data.

Battery Replacement

1. Locate the battery cover on the back of the scale. Push the locking tab and pull the battery cover up.
   
2. Use the tip of a pen to loosen the battery. Hold the scale at an angle to allow the battery to slide out.
   
3. Insert one new battery with the + side facing up, and press it firmly into its slot.
   
4. Replace the battery cover.
   

TROUBLESHOOTING

If " E " appears on the display:

• You may have stepped on the scale before it displayed "0.0".
• The scale cannot detect a stable weight. Stand still while weighing.
• The weight has exceeded the scale's capacity (330 lb/150 kg).

NOTE: Display will turn off automatically in 20 seconds if no key is pressed.

IT IS NORMAL FOR YOUR WEIGHT TO VARY DURING THE DAY AND FROM ONE DAY TO ANOTHER.

© 2005 Sunbeam Products, Inc. All rights reserved. Health o meter^® is a trademark of Sunbeam Products, Inc. Boca Raton, FL 33431.