Stopping The Machine; Attachment Lift Lever - Toro Wheel Horse 265H Operator's Manual

Operation

Stopping the Machine

To stop the machine, release the traction control
pedal, disengage the power take off (PTO), and turn
the ignition key to "OFF" to stop the engine. Also set
the parking brake if you leave the machine
unattended; refer to Setting the Parking Brake,
page 12. Remember to remove the ignition and "key
choice" keys from the switchs.
POTENTIAL HAZARD
Someone could move or attempt to operate
the tractor while it is unattended.
WHAT CAN HAPPEN
Children or bystanders may be injured if
they use the tractor.
HOW TO AVOID THE HAZARD
Always remove the ignition and "key
choice" keys and set the parking brake
when leaving the machine unattended, even
if just for a few minutes.
18

Attachment Lift Lever

The attachment lift lever (Fig. 11) is used to raise and
lower various attachments.
Raising Attachments
1. Depress the brake pedal to stop the machine.
2. Pull attachment lift lever rearward until latch
locks. In this position the lift will hold the
attachment in the up, or raised position.
Lowering Attachments
1. Depress the brake pedal to stop the machine.
2. Pull attachment lift lever rearward, to release lift
pressure, and push the button on top to release
the latch. Move lift lever forward to lower
attachment.
2
1
Figure 11
1. Lift lever
2. Button
3. Dial-A-Height
3
5
4
6
1205
4. Indicator
5. High
6. Mounting position