Toro Wheel Horse 265H Operator's Manual page 36

Maintenance
1
4
2
3
Figure 37
1. Battery
2. Side panel tabs
3. Screw
Checking Electrolyte Level
1. Open the hood to see the battery.
2. Open covers to see into the cells. The electrolyte
must be up to the lower part of the tube
(Fig. 38). Do not allow the electrolyte to get
below the plates. (Fig. 38).
3. If the electrolyte is low, add the required amount
of distilled water; refer to Adding Water to the
Battery, page 34.
2
Figure 38
1. Filler caps
2. Lower part of tube
Adding Water to the Battery
The best time to add distilled water to the battery is
just before you operate the machine. This lets the
water mix thoroughly with the electrolyte solution.
34
4
5
1260
4. Wing nut
5. Pin
1
3
1262
3. Plates
1. Clean the top of the battery with a paper towel.
2. Lift off the filler caps (Fig. 38).
3. Slowly pour distilled water into each battery cell
until the level is up to the lower part of the tube
(Fig. 38).
IMPORTANT: Do not overfill the battery
because electrolyte (sulfuric acid) can cause
severe corrosion and damage to the chassis.
4. Press the filler caps onto the battery.
Charging the Battery
IMPORTANT: Always keep the battery fully
charged (1.260 specific gravity). This is
especially important to prevent battery
damage when the temperature is below 32 F
(0 C).
1. Remove the battery from the chassis; refer to
Removing the Battery, page 33.
2. Check the electrolyte level; refer to Checking
Electrolyte Level, page 34, steps 2–3.
3. Remove the filler caps from the battery and
connect a 3 to 4 amp battery charger to the
battery posts. Charge the battery at a rate of 4
amperes or less for 4 hours (12 volts). Do not
overcharge the battery. Install the filler caps after
the battery is fully charged.
POTENTIAL HAZARD
Charging the battery produces gasses.
WHAT CAN HAPPEN
Battery gasses can explode.
HOW TO AVOID THE HAZARD
Keep cigarettes, sparks and flames away
from battery.
4. Install the battery in the chassis; refer to
Installing the Battery, page 33.