Advertisement
5.5.2.
Fan only mode (fig.9).
fig.9
5.5.3.
Dehumidifying mode (fig.10).
fig.10
5.5.4.
Heating mode (fig.11).
fig.11
6. MAINTENANCE
NOTE: repair of unit and handling of refrigerant must only be carried out by a suitably qualified person.
6.1.
GENERAL MAINTENANCE
Turn the unit OFF and disconnect it from the mains power supply before cleaning or performing any maintenance.
6.1.1.
Inspect the unit on a regular basis and replace or repair any damaged parts. Use recommended parts and an authorised service
agent. Unauthorised parts may be dangerous and will invalidate the warranty.
DO NOT use any solvents or abrasive material to clean the plastic exterior of the unit. Use only a damp soft cloth for cleaning and dry
8
the unit afterwards with a clean, dry, soft cloth.
6.2.
AIR FILTERS. Clean the air filters every two weeks for optimum performance. The filters are situated at the rear of the unit (figs.12
and 13), and are held in place by plastic frames.
6.2.1.
Upper Filter
Pull the top handle gently to release the holding lugs and remove the filter frame.
6.2.2.
Lower Filter
Pull the corner handle gently to release the holding lugs and remove the filter frame.
6.2.3.
Once released, remove the filter from the frame and tap it gently to remove dust, or vacuum it gently if it is very clogged with dirt.
6.2.4.
If the filter is heavily soiled, it can be washed in warm water containing a mild, neutral detergent. Ensure that the filter is dry completely
before installing it.
6.2.5.
To replace the filter, first insert the two bottom tags of the filter frame into the bottom edge of the filter frame recess in the unit. Lay the
filter into the filter frame and hinge the frame forwards into the recess. Push the top of the frame inwards until the two clips snap into
place.
6.2.6.
Refitting the filter frames into the machine is the opposite of 6.2.1./6.2.2.
6.3.
STORAGE
6.3.1.
If the unit is not to be used for a long period of time, drain off any water in the tank. Place a large enough container under the rear of
the unit, remove the rubber drainage stopper (fig.7) to allow the tank to drain. When the tank is empty, replace the stopper firmly. Clean
the unit and air filter as above, and store in a safe, dry area, out of the reach of children.
© Jack Sealey Limited
Get In Touch
Call: 0845 6880112
Email: info@adremit.co.uk
fig.12
Original Language Version
Our Address
Puravent, Adremit Limited, Unit 5a, Commercial Yard,
Settle, North Yorkshire, BD24 9RH
fig.13
SAC12000.V3 Issue 1 11/03/20
Advertisement
