Mounting And Removing X-Lock; Wheels - Bosch TG503 Operating/Safety Instructions Manual

Mounting and Removing X-Lock

Wheels

(Fig. 10, Fig. 12, Fig. 13, Fig. 15)
Only use Bosch or Bosch li-
censed
ries. Incompatible accessories may not clamp
properly resulting in personal injury and/or
property damage.
Confirm proper clamping
by ensuring that top of the
accessories's X-Lock mounting hub surface is
not above the top of the clamping height gage.
Accessories that are above the clamping height
gauge may not be fixed properly and separate
from the the tool causing personal injury and/
or property damage.
Always inspect accessory
mount
clamping flange before use. Do not use the
tool or accessory if the accessory mount or ac-
cessory is damaged or deformed. Accessoies
that are not clamped properly may cause per-
sonal injury and/or property damage.
Check
buildup of foreign material
on clamping surfaces and remove before use.
Unwanted material
clamping and may cause personal injury and/or
property damage.
Never actuate X-Lock Re-
lease Lever while accessory
is moving. Make sure that the accessory has
come to a complete stop before removing the
accessory. Releasing an accessory while still
spinning could cause personal injury and/or
property damage.
Do not use a damaged ac-
cessory. Before each use in-
spect the accessory such as abrasive wheels for
chips and cracks, backing pad for cracks, tear
or excess wear, wire brush for loose or cracked
wires. If power tool or accessory is dropped,
inspect for damage or install an undamaged ac-
cessory. After inspecting and installing an ac-
cessory, position yourself and bystanders away
from the plane of the rotating accessory and
run the power tool at maximum no-load speed
for one minute. Damaged accessory will nor-
mally break apart during this test time.
TG503 Tuck Point Grinder Guard OSI Final 20230606.indd 17 TG503 Tuck Point Grinder Guard OSI Final 20230606.indd 17
Assembly
X-LOCK accesso-
and accessory
for presence
can cause incomplete
Verify that the Wheel 14 and the X-Lock Wheel
Mount 17 on the tool are not deformed and
are free from dirt. If necessary, clean the area
around the two X-Lock Clamping Tabs 36.
Verify that both Clamping Tabs 36 are open (Fig.
10) before fitting the X-Lock Wheel 14 (Fig. 13).
Fig. 12
or
Fig. 13
30
-17-
8
28 29
14
16
16
6/6/2023 1:43:03 PM 6/6/2023 1:43:03 PM
30
15
17