Replacing a Fuse
The electrical system is protected by fuses and requires no maintenance. If a fuse blows,
check the component or circuit for a malfunction or short.
1. Release the cushion from the rear of the machine.
2. Pull out the fuse to remove or replace it.
3. Install the cushion to the rear of the machine.
Note:
If a fuse blows a second time, check the component/circuit for a malfunction or a short or
contact your Authorized Service Dealer.
Drive System Maintenance
Track Service
Cleaning the Tracks
1. Park the machine on a level surface, move the motion-control levers to the N
position, engage the parking brake, and lower the hopper.
2. Shut off the engine, and remove the key. Allow the engine to cool.
3. Lift/support the side of the machine to be worked on so that the track is 7.6 to 10 cm (3
to 4 inches) off the ground.
Maintenance: Electrical System Maintenance
G376375
Ensure that the correct-size fuse is installed.
Page 5–15
Main power fuse (15 A)
Auxiliary power fuse (15 A)
Logic fuse (7.5 A)
EUTRAL
-
LOCK
3461-433 A