Installing Bbu In Server - NEC Promise SuperTrak EX8350 User Manual

20

1-5. Installing BBU in Server

Install the BBU in the disk array controller and the server in the following procedure:
1.
Remove the additional slot cover and screw from an unused PCI slot. Remove the cables from the
disk array controller.
2.
Remove the disk array controller from the server, and connect the battery cable to the battery
connector on the disk array controller.
NOTE:
The BBU has two battery cable connectors. Either of two connectors may be
used. Select either connector appropriate to your system environment (e.g., location to
install in the server and cable routing condition) to connect the battery cable.
3.
Insert the BBU and disk array controller into the PCI slot and fix the BBU with the screw removed
previously.
Screws
To install the BBU in the server, an empty PCI slot is required in the server.
Before the installation, make sure that at least one unused PCI slot remains
in the server.
Notice
4.
Install the side cover on the server. Connect the cable to the disk array controller and power cord to
the receptacles to recover the original state.
Screw
BBU
Battery cable
Disk array controller