Panasonic SH-FX60 Operating Instructions page 3

Connecting the digital transceiver
Insert the digital transceiver into the slot of your home
theater unit.
e.g.
Do not insert or remove
while the home theater
unit is on.
Rear of the home theater unit
Making the wireless link
Refer also to the operating instructions for your home theater unit.
1
Turn on your home theater unit.
≥Ensure the wireless system is connected to the mains socket.
2
Check the wireless link indicator on the home theater
unit.
" [W] " or LED should light up on the home
theater unit.
≥If " [W] "or LED is flashing, refer to
Troubleshooting guide.
AC IN
AC supply indicator [AC IN]
This indicator lights when the unit is connected
to the AC mains supply.
WIRELESS LINK
Lighting Ring
Lights when the wireless link is active.
Digital transceiver
Insert fully until you hear a click.
e.g.
Connecting the surround speaker cables
to the wireless system
1
If the surround speaker cables have already been connected
Disconnect the surround speaker cables from your
home theater unit.
2
Connect the surround speaker cables to the wireless
system.
AC IN~
AC mains lead
To household mains
socket
(AC 230 to 240 V,
50 Hz)
3
Start play on the home theater unit.
Conserving power
The wireless system consumes a small amount of power when it is in standby
mode (approx. 4 W).
To save power when the unit is not to be used for a long time, unplug it from
the household mains socket.
W
[Note[
The unit is in the standby condition when the AC power supply cord is
connected. The primary circuit is always "live" as long as the power cord is
connected to an electrical outlet.
Flip the tab open.
L R
Insert the wire
fully.
i: White
j: Blue
Surround speaker cable (R)
Surround speaker cable (L)
Flip the tab closed.
Click!