Table of Contents
Advertisement
Quick Links
R Door station is described as "doorphone" and Main monitor station is described as "main
monitor" in this guide.
R In this guide, the suffix of each model number (e.g., the "BX" in "VL-SV70BX") is omitted
unless necessary.
Note to the installer
R Before attempting to connect or operate this product, please read the nameplate on the
bottom or rear of the product.
R Please read this guide carefully, and install the product safely and correctly by following
the instructions. Carefully read the information found in the section titled "For your
safety" in particular.
R Only use attachments/accessories specified by the manufacturer.
R The installation shall be carried out in accordance with all applicable installation rules.
R To the maximum extent permitted by law, Panasonic assumes no responsibility for
injuries or property damage resulting from failures arising out of improper installation
or operation inconsistent with this document.
R After installation, make sure to leave this guide with the customer.
Model Name
Video Intercom System
Door station
Installation Guide
Main monitor station
Model No.
VL-SV70
Advertisement
Table of Contents
Related Manuals for Panasonic VL-SV70
Summary of Contents for Panasonic VL-SV70
- Page 1 R Only use attachments/accessories specified by the manufacturer. R The installation shall be carried out in accordance with all applicable installation rules. R To the maximum extent permitted by law, Panasonic assumes no responsibility for injuries or property damage resulting from failures arising out of improper installation or operation inconsistent with this document.
-
Page 2: For Your Safety
– Places where the main monitor may For your safety be splashed with water or chemicals. – Places where there is a high To prevent severe injury and loss of life/ concentration of dust, or high property, read this section carefully humidity. -
Page 3: Supplied Accessories For Installation
Supplied accessories for installation For the doorphone Screw ´ 2 (3.8 mm ´ 20 mm) For the main monitor Screw ´ 2 (4 mm ´ 16 mm) Mounting bracket ´ 1 Important: R You will need the following additional items to install and configure the doorphone and the main monitor. -
Page 4: Precautions For Installation
Precautions for installation To avoid malfunction or communication disturbances, do not install the doorphone or the main monitor in the following locations: – Places where vibration or any other kind of impact occurs. – Places where echoing is frequent. – Places near a high concentration of dust, hydrogen sulphide, ammonia, sulphur, or noxious fumes. For the doorphone R If a strong light is shining on the doorphone, the visitor’s face may not be distinguishable. - Page 5 Wiring schematic diagram Set up correctly according to the following wiring schematic diagram and "Wire type and length". R For information, such as order numbers, about optional devices that can be connected to, refer to the "Additional/replacement accessories" section in the Operating Instructions. DOORPHONE 1 MAIN MONITOR Connection device...
- Page 6 Wire type and length Wire type Wiring run Diameter Length (Max.) ø 0.65 mm 22 AWG 100 m Doorphone – ø 1.0 mm 18 AWG 130 m Main monitor ø 0.5 mm CAT 5 50 m According to the Main monitor – ø...
-
Page 7: Doorphone Installation Position
Doorphone installation position Installation position of the doorphone and camera range Views when the camera is facing forwards at 0° (default). R Example: Installation height is 1450 mm (standard position). (Units: mm) A view when looking from above A Image range B Approx. 66° C Centre of doorphone D Approx. 1450 E Approx. 500 F Approx. -
Page 8: Installing The Doorphone
Attach the mounting base (A) to the wall Installing the doorphone securely using the wood screws (B) (accessory). Important: R Install the mounting base on a vertical flat wall. R On the bottom surface of the doorphone and the R Before drilling, refer to “Precautions for mounting base, there are holes to allow water to installation”... - Page 9 Examples of camera angle Mount the doorphone to the mounting base. Fasten the screw, then close the Facing forwards Facing upwards screw cover (C). Facing left Facing upper left R The angle can also be adjusted to the right or upper right. Important: R When the camera angle is adjusted to the upper left or upper right, the image may be...
-
Page 10: Main Monitor Installation Position
Main monitor installation Installing the main monitor position Attach the mounting bracket (A) to the wall securely. About the installation position of the main R Install the mounting bracket on a vertical flat monitor and mounting bracket wall (B). R Place the main monitor in a location that your eyes are the same height as the centre of the display. - Page 11 Mount the main monitor to the mounting bracket. 3-1 Line up the tab on the bottom of the bracket with the groove on the main monitor. 3-2 Line up the tab on the top of the bracket with the groove on the main monitor, and push the main monitor down until it is secure.
- Page 12 Notes...
- Page 13 Notes...
- Page 14 Notes...
- Page 15 Notes...
- Page 16 1006, Oaza Kadoma, Kadoma-shi, Osaka 571-8501, Japan http://www.panasonic.com © Panasonic Corporation 2020 PNQX9134ZA C1020MM0...