Editing The Network Settings; Setting Up Communication Between Pcm600 And The Ied - Hitachi Relion 670 Series Quick Start Manual

1MRK500129-UEN Rev. J
Section 8
Before starting the PCM600 program, edit the network settings of the computer system. The
computer system and the IED should be configured to communicate correctly because both will be
available on the same network. This is possible when the IED and the computer system have the
same Subnet Mask but different IP addresses.
Figure shows this concept and the addresses are used as an example; other addresses can also be
used.
IEC18000032 V2 EN-US
Figure 16:
Based on the version of the Windows operating system, follow the instructions to edit network
settings.
8.1 Setting up communication between PCM600 and the
IED
The communication between the IED and PCM600 is independent of the communication protocol
used within the substation or to the NCC.
670/650 series
Quick start guide

Editing the network settings

Network settings to connect PC with an IED
The PCM600 software version 2.8 or later is used to connect to the IED that supports
Windows XP, 7, 8, 8.1, and 10.
© 2018 - 2023 Hitachi Energy. All rights reserved.
Section 8
Editing the network settings
GUID-46742F3A-48A3-4C24-A354-AD721C69023C v1
SEMOD58570-5 v16
35