Table of Contents
Advertisement
St ep 1 Preparing t he pow er supply
Charging t he bat t ery pack
Use the battery pack after charging it for your camcorder.
Your camcorder operates only with the "InfoLITHIUM" battery pack (L series). If you
want to use the camcorder right away indoors, use on the AC adaptor/charger (p. 15).
(1) Set the mode change switch to "CHARGE."
(2) Connect the power cord to the AC adaptor/charger.
(3) Connect the power cord to a wall outlet.
(4) Place the battery pack on the AC adaptor/charger with the b mark facing the
(5) Slide the battery pack in the direction of the arrow.
Charging begins. When the remaining battery indicator becomes
CHARGE lamp lights up, normal charge is completed. For full charge, which allows
you to use the battery slightly longer than "normal charge," leave the battery pack
attached until the CHARGE lamp goes out.
Remove the battery pack when required. It can be used even if the charging is not
completed.
1
To rem ove t he bat t ery pack
Slide the battery pack in the opposite direction of installing, then lift it straight out.
10
Downloaded from:
A beep sounds and the display window lights up.
terminal shutter.
Press the battery pack until the terminal shutter enters completely into the AC
adaptor/charger.
3
VTR/CAMERA CHARGE
https://www.usersmanualguide.com/
2
4, 5
and the
CHARGE lamp
Advertisement
Table of Contents
