• Cleaning and user maintenance shall not be made by children without supervision. General Safety • The appliance and its accessible parts become hot during use. Do not touch the heating elements. • Do not operate the appliance by means of an external timer or separate remote-control system. www.zanussi.com...
• Make sure not to cause damage to the mains • The bottom of the appliance can get hot. We plug (if applicable) or to the mains cable. recommend to install a non-combustile sepa- Contact the Service or an electrician to change a damaged mains cable. www.zanussi.com...
Page 4
There is a risk of over- or as a storage surface. heating and rupture of the glass plate (if ap- • If the surface of the appliance is cracked, plicable). disconnect immediately the appliance from www.zanussi.com...
Product description Cooking surface layout Semi-rapid burner Semi-rapid burner Control knobs Auxiliary burner Rapid burner Control knobs Symbol Description ignition position / maxi- Symbol Description mum gas supply no gas supply / off posi- tion minimum gas supply Daily use www.zanussi.com...
• If possible, always put the lids on the pans. Auxiliary 80 - 180 mm • When the liquid starts to boil, turn down the flame to barely simmer the liquid. Use cookware with diameters applicable to the size of burners. www.zanussi.com...
• When you wash the pan supports by hand, 3. At the end rub the appliance dry with a take care when you dry them as the enamel- clean cloth. ling process occasionally leaves rough edges. If necessary, remove stubborn stains using a paste cleaner. www.zanussi.com...
5 seconds. The gas ring burns unevenly • Burner crown is blocked with • Make sure that the injector is food residues not blocked and the burner crown is clear of food particles. www.zanussi.com...
Also be compliance with standards and local careful when the hob is put together with an regulations in force. oven. www.zanussi.com...
Page 10
Warning! Make sure the flame does not make sure that the seal of each pipe fitting is go out when you quickly turn the knob correct. Use a soapy solution, not a flame! from the maximum position to the minimum position. www.zanussi.com...
Page 11
Replacement of the connection cable To replace the connection cable use only H05V2V2-F T90 or equivalent type. Make sure that the cable section is applicable to the volt- age and the working temperature. The yellow/ www.zanussi.com...
>PE<,>PS<, etc. Discard the packaging mate- otherwise be caused by inappropriate waste rials as household waste at the waste disposal handling of this product. For more detailed facilities in your municipality. www.zanussi.com...