Assembly; Unpacking - Bosch rexroth DB20K.1X E Series Operating Instructions Manual

7 Assembly

High pressure!
Risk of injury due to parts shooting out during works at hydraulic accumulators
which have not been unloaded.
Carry out any work at the safety valve only after the system has been
f
depressurized.
Unload accumulators which may have been mounted at the system.
f
Check the system with test pressure according to ISO 4413.
f
Assembly and commissioning may only be carried out by specialists.
f
Leaking hydraulic fluid!
Slip hazard!
Do not remove the protective covers until assembly.
f
Immediately remove leaking oil.
f
Insufficient assembly space!
Risk of jamming and bruising! Risk of component damage! Insufficient installation
space may lead to jamming or abrasions in case of actuation or adjustment works
at the safety valve. Components cannot be properly mounted or might be damaged.
Make sure that the assembly space is sufficient.
f

7.1 Unpacking

Parts falling out!
Risk of injury! If the packaging is opened improperly, parts may fall out and cause
injuries or damage of the parts.
Put the packaging on level, bearing ground.
f
Only open the packaging from the top.
f
The response pressure has been set by the manufacturer and secured by means of
lead seal and/or protective cap.
Check whether the sealing and/or the protective cap is undamaged.
f
Dispose of the packaging in accordance with the national conditions of your country.
CAUTION
CAUTION
RE 25818-B/11.21, DB20K.1X/...E, Bosch Rexroth AG
Assembly 21/40