Toro 07433LT Operator's Manual page 21

when approaching blind corners, shrubs, trees, or
other objects that may obscure your vision.
•
Do not drive the machine near drop-offs, ditches,
or embankments. The machine could suddenly
roll over if a wheel goes over the edge or if the
edge gives way.
•
Always watch out for and avoid low overhangs
such as tree limbs, door jambs, overhead
walkways, etc.
•
Look behind and down before reversing the
machine to be sure of a clear path.
•
When using the machine on public roads, follow
all traffic regulations and use any additional
accessories that may be required by law, such as
lights, turn signals, slow-moving vehicle (SMV)
signs, and others as required.
•
If the machine ever vibrates abnormally, stop
and shut off the machine immediately, wait for
all movement to stop, and inspect for damage.
Repair all damage to the machine before resuming
operation.
•
It can take longer to stop the machine on wet
surfaces than on dry surfaces. To dry out wet
brakes, drive slowly on level ground while putting
light pressure on the brake pedal.
•
Operating the machine at high speed and then
quickly stopping may cause the rear wheels to lock
up, which impairs your control of the machine.
•
Do not touch the motor while the motor is running,
or soon after you turn off the motor, because these
areas may be hot enough to cause burns.
•
Do not leave a running machine unattended.
•
Before you leave the operating position, do the
following:
– Park the machine on a level surface.
– Engage the parking brake.
– Shut off the machine and remove the key.
– Wait for all movement to stop.
•
Do not operate the machine when there is the risk
of lightning.
•
Use accessories and attachments approved by
The Toro® Company only.
Multi-Passenger Safety
•
Do not exceed the gross vehicle weight (GVW)
of the machine. You must account for yourself,
your passengers, and the load in the cargo bed
contributing to the overall GVW of the machine.
•
Passengers should sit in the designated seating
positions only. Do not allow passengers to sit in
the cargo bed.
•
You and your passengers should remain seated
whenever the machine is in motion.
•
The additional machine length results in a larger
turn radius, so allow more space to maneuver the
machine.
Slope Safety
Note:
A 2-post Rollover Protection System (ROPS)
is available for this machine as an accessory. Use a
ROPS if you will work next to drop-offs, near water,
in rough terrain, or on a slope, which could result in
a rollover. Contact an authorized Toro distributor for
more information.
Slopes are a major factor related to loss-of-control
and tip-over accidents, which can result in severe
injury or death.
•
Survey the site to determine which slopes are
safe for operating the machine and establish your
own procedures and rules for operating on those
slopes. Always use common sense and good
judgment when performing this survey.
•
If you feel uneasy operating the machine on a
slope, do not do it.
•
Keep all movement on slopes slow and gradual.
Do not suddenly change the speed or direction of
the machine.
•
Avoid operating the machine on wet terrain. Tires
may lose traction. A rollover can occur before the
tires lose traction.
•
Travel straight up and down a slope.
•
If you begin to lose momentum while climbing a
slope, gradually engage the brakes and slowly
reverse the machine straight down the slope.
•
Turning while going up or down a slope can be
dangerous. If you must turn on a slope, do it slowly
and cautiously.
•
Heavy loads affect stability on a slope. Carry a
reduced load and reduce your ground speed when
operating on a slope or if the load has a high
center of gravity. Secure the load to the cargo bed
of the machine to prevent the load from shifting.
Take extra care when hauling loads that shift easily
(e.g., liquids, rock, sand, etc.).
•
Avoid starting, stopping, or turning the machine
on a slope, especially with a load. Stopping while
going down a slope takes longer than stopping
on level ground. If you must stop the machine,
avoid sudden speed changes, which can cause
the machine to tip or roll over. Do not engage the
brakes suddenly when rolling rearward, as this
may cause the machine to overturn.
21