Table of Contents
Advertisement
Pre-Maintenance
Procedures
WARNING
Raise the cargo bed before performing
maintenance. A raised cargo bed can fall and
injure persons that are underneath it.
• Always use the prop rod to hold the cargo
bed up before working underneath it.
• Remove any load material from the cargo
bed before working underneath it.
Preparing the Machine for
Maintenance
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the machine and remove the key.
4.
Empty and raise the cargo bed.
Lifting the Machine
DANGER
The machine may be unstable when using
a jack. The machine could slip off the jack,
injuring anyone beneath it.
• Do not start the machine while the machine
is on a jack.
• Always remove the key from the key switch
before getting off the machine.
• Block the tires when the machine is
supported by lifting equipment.
• Use jack stands to support the machine
once you have lifted it.
Important:
Whenever you run the machine for
routine maintenance and/or diagnostics, ensure
that the rear wheels of the machine are 25 mm (1
inch) off the ground, with the rear axle supported
on jack stands.
•
The lifting point at the front of the machine is
located at the front of the frame, behind the towing
tongue
(Figure
29).
1. Front lifting point
•
The lifting point at the rear of the machine is
located under the axle tubes
1. Rear lifting points
Accessing the Hood
Raising the Hood
1.
Lift up the handle of the rubber latches on each
side of the hood
33
Figure 29
(Figure
30).
Figure 30
(Figure
31).
g319293
g319294
Advertisement
Table of Contents
