Advertisement
4. Running User code on the LPC90x using PAB90x-1
When a device has been successfully programmed, use the following steps to run
the programmed code:
Step1: Disconnect the power cable from the MCB900 board
Step 2: Put the 3 jumpers on the PAB90x-1 board to RUN mode
Step 3: Reconnect power – your user code is now running.
To see the UART sending the string from the "Hello World" example you can open
a terminal program, e.g. HyperTerminal:
-
To have access to the COM port of the PC, start the program
'HyperTerminal'. (START | PROGRAMS | ACCESSORIES |
COMMUNICATIONS | HYPERTERMINAL)
-
Click on 'Properties' and check the following settings: 9600 baud, 8 data bits,
1 stop bit and no flow control.
The P89LPC903 will send "Hello World : )" through the UART with 1 sec
-
delays, which is displayed on the screen.
PAB90x-1 Getting Started V1.0
Jumpers to RUN mode
Page 12
Advertisement
