Philips PAB90 1 Series Getting Started Manual page 7

• Connect the MCB900 to your PC COM port using a serial cable.
• Power up the MCB900 board.
• Start FlashMagic (Start | Programs | FlashMagic | FlashMagic)
• Go to "Options | Advanced Options | Hardware Config" and make sure
the box "Use DTR and RTS to enter ISP mode" is clicked:
• Go to "Options | Advanced Options | Security" and make sure the
"Protect ISP code" option is selected:
• Select the COM port you will be using to program the LPC932.
• Select the P89LPC932 as the device to be programmed
• Select baud rate 9600
• Browse to the prog90x.hex file that is on the CD in the "ISP ICP bridge
source code" folder
• Check the "erase all" Flash box.
PAB90x-1 Getting Started V1.0 Page 7