Siemens SIREMOBIL Compact Installation And Setting Instructions Manual page 6

6
Programming
(To be performed only if the system is not equipped with a multi-format camera or a video
printer.)
For Memoskop C (with keyboard):
•
Switch on the system.
•
Simultaneously press the [CTRL] and [U] keys on the Memoskop keyboard.
This calls up the User Setup menu for the Memoskop.
•
Select the "C Documentation" sub-menu.
•
Configure monitor A for a SIREMOBIL Compact with one monitor.
•
Configure monitor B for a SIREMOBIL Compact with two monitors.
•
If the system is equipped with an area dose measurement device (Diamentor) , call up
the "K Documentation of Dose" sub-menu and configure "yes".
•
Exit the User Setup program.
For Memoskop C-E (without keyboard)
•
Switch on the system.
•
Locate the adapter connector installed at the Memoskop C-E keyboard connector.
•
Connect the service PC to the Memoskop C-E adapter connector and start Windows.
•
Call up the "terminal.exe" program.
•
Set the following in the "terminal.exe" menu::
•
Set the interface used (COM1 / COM2).
•
The keyboard will be emulated by the service PC.
NOTICE 1
NOTICE 2
SIREMOBIL Compact
9600 Baud 8 Bit
The "Home" key (>|<) is not present on the service PC keyboard.
Enter the letter O in the User Setup main menu instead.
In the User Setup sub-menus, enter the number which follows the
last number displayed.
For example: The last sub-menu is selected by entering 12. -> The
number 13 then represents the "Home" (>|<) key.
The key codes for the keys [<] and [>] differ from the MEMOSKOP
keyboard to the PC keyboard. Therefore, the service PC uses the
[Backspace] and [/] keys to emulate the [<] and [>] cursor keys
respectively.
For PC's with German keyboards, the code [/] is produced by
simultaneously pressing the [Shift] and [7] keys.
Register 3 RXR2-130.033.02
Rev. 02
Connecting laser camera
Parity none
Page 6 of 8
03.97 TD SP 1
1 Stopbit
Siemens AG
Medical Engineering
1
1
1