Advertisement
Let the water boil.
3. When the water and unit have cooled, discard the water. Rinse with cold water
and repeat.
4. Your electric kettle is now ready for use.
Using your Electric Kettle
1. Position the power base on a flat, heat resistant surface, as close as possible to
a power outlet.
2. Follow cord routing in power base according to exit patterns. Proper cord routing
will result in the power base laying flat when kettle is placed in base. DO not
operate kettle if power base is not flat. If power base is not flat, remove kettle from
power base and repeat cord placement instructions.
3. To fill with water, remove the lid. Fill the electric kettle with water to below the
"MAX" water level mark. NOTE: Do not exceed the "MAX" water level mark
indicated on the electric kettle.
4. Plug the electric cord into an electric outlet. Turn the switch ON by pushing
down on the on/off switch. The indicator light will light to indicate the unit is on. The
water will heat and the electric kettle will switch off automatically when the water
boils. NOTE: Ensure the ON/OFF switch is clear of obstructions and the lid is firmly
closed. The electric kettle will not turn off automatically if the ON/OFF switch is
constrained, or if the lid is left open.
5. Carefully lift the kettle from the power base and pour the hot water.
6. The kettle will not re-boil until the on/off switch is again switched ON. Wait 25
seconds, allowing kettle to cool down, then switch ON.
IF THE KETTLE DOES BOIL DRY
If the kettle is operated in accordance with instructions for use, it is unlikely that the
kettle will boil dry. However, in the event that the kettle does boil dry, it is protected by
a boil dry, fail-safe device which will switch the kettle off automatically on sensing a
boil dry situation and keep it switched off until the kettle is refilled with at least the
minimum amount of water. Always allow the kettle to cool for half an hour before
reuse if the kettle has boiled dry.
Care and cleaning of your electric kettle
Advertisement
