Servicing The Bedbar - Toro 03623 Operator's Manual

Figure 27
1. Bedknife (vertical)
2. Press the Alt Zero button on the angle indicator.
3. Place the angle-indicator mount on the edge of
the bedknife so that the edge of the magnet is
mated with the edge of the bedknife
Note:
The digital display should be visible from
the same side during this step as it was in step 1.
Figure 28
1. Angle-indicator mount
2. Edge of the magnet mated
with the edge of the
bedknife
4. Place the angle indicator on the mount as shown
in Figure 28.
Note:
This is the angle that your grinder
produces, and should be within 2 degrees of the
recommended top grind angle.
g034113
2. Angle indicator
(Figure 28).
g034114
3. Bedknife
4. Angle indicator

Servicing the Bedbar

Removing the Bedbar
1. Turn the bedbar-adjusting screws
counterclockwise to back the bedknife
away from the reel
1. Bedbar-adjusting screw
2. Spring-tension nut
2. Back out the spring-tension nut until the washer
is no longer tensioned against the bedbar
(Figure 29).
3. On each side of the machine, loosen the locknut
securing the bedbar bolt
1. Bedbar bolt
4. Remove each bedbar bolt, allowing the bedbar
to be pulled downward and removed from the
machine bolt (Figure
Note:
Account for 2 nylon washers and 1
stamped steel washer on each end of the bedbar
(Figure 31).
18
(Figure 29).
Figure 29
3. Bedbar
4. Washer
(Figure 30).
Figure 30
2. Locknut
30).
g027175
g003334