Servicing The Bedbar - Toro 04019 Operator's Manual

Note: Use the following table and Figure 64 to set the rate of clip.
Clip (Refer to Figure 64 for pulley locations.)
Drive Driven
pulley pulley
number number of
of teeth teeth
27 22
(standard) (standard)
22* 22
22 27
* An additional 22 tooth pulley is required for this clip setting.
Contact your local Authorized Toro Distributor for assistance.
The clip can only be changed on the reel drive
(Figure 64). Do not change the drive ratio on the
gearbox pulleys.
1. Reel drive belt
2. Drive pulley

Servicing the Bedbar

Removing the Bedbar
1. Turn the bedbar adjuster screw, counterclockwise, to
back the bedknife away from reel (Figure 65).
14 Blade 11 Blade
Clip Clip
inch (mm) inch (mm) inch (mm)
0.112 (2.9) 0.143 (3.6) 0.197 (5.0)
0.138 (3.5) 0.176 (4.5) 0.241 (6.1)
0.172 (4.4) 0.219 (5.6) 0.301 (7.7)
Figure 64
3. Driven pulley
8 Blade
Clip
1. Bedbar adjusting screw
2. Spring tension nut
3. Bedbar
2. Back out the spring tension nut, until the washer is
no longer tensioned against the bedbar (Figure 66).
3. On each side of the machine, loosen the jam nut
securing the bedbar bolt (Figure 66).
1. Bedbar bolt
4. Remove each bedbar bolt allowing bedbar to be
pulled downward and removed from machine.
Account for 2 nylon and 2 stamped steel washers on
each end of bedbar (Figure 67).
36
Figure 65
4. Jam nut
5. Bedbar bolt
Figure 66
2. Nut