Installing The Cutting Unit To The Traction Unit; Installing The Handle - Toro 04019 Operator's Manual

1
Installing the Cutting Unit to
the Traction Unit
Parts needed for this procedure:
2 Bolt, M10 x 25mm
1. Place the mower on its drums on a level surface.
2. Lower kick stand. Insert a 1/4" dia. pin or equivalent
into frame hole above kick stand mounting bolt
(Figure 4).
1. 1/4" Pin
2. Handle
3. Push the cutting unit under the traction unit and
then to the left to engage the transmission coupling
(Figure 5).
1. Transmission coupling
Figure 4
3. Kick stand
Figure 5
4. Rotate the traction unit frame (Figure 6)forward until
it engages the cutting unit pivot arms.
5. Secure the traction unit frame to the cutting unit
pivot arms with (2) M10 x 25mm bolts (Figure 6)
1. Cutting unit pivot arms
2. Traction unit frame
Note: When tightening the pivot arm mounting
fasteners, use an adjustable end wrench to hold the
pivot arm parallel to the side plate (Figure 7)
10
Figure 6
3. Bolts
Figure 7