Cutting Unit Maintenance; Separating The Cutting Unit From The Traction Unit; Adjusting The Rear Roller - Toro 04019 Operator's Manual

Cutting Unit Maintenance

Separating the Cutting Unit
from the Traction Unit
1. Place the mower on its drums on a level surface.
2. Lower kick stand. Insert a 1/4" dia. pin or equivalent
into frame hole above kick stand mounting bolt
(Figure 51).
Figure 51
1. 1/4" Pin
2. Handle
3. Remove grass basket.
4. Remove (2) bolts securing cutting unit pivot arms to
traction unit frame tube (Figure 52).
Figure 52
1. Cutting unit pivot arms
2. Traction unit frame tube
5. Rotate pivot arms forward (Figure 52) and rest
traction unit on restrained kickstand.
6. Pull cutting unit forward about 2 inch (51 mm)
and then to the right to disengage the transmission
coupling (Figure 53).
3. Kick stand
3. Bolts
1. Transmission coupling
7. Reverse procedure to install cutting unit.
Note: When tightening the pivot arm mounting
fasteners, use an adjustable end wrench to hold the
pivot arm parallel to the side plate (Figure 54).

Adjusting the Rear Roller

1. Adjust the rear roller brackets to the low or high
position depending on desired height of cut range
(Figure 55and Figure 56).
• Position the spacer above the sideplate mounting
flange (factory setting) when height of cut
settings range from 1/16 to 1/4" (Fig. 10).
31
Figure 53
Figure 54