Wall Mounting - Bosch Integrus Installation And Operation Manual

Integrus
Figure 5.11 Attaching the radiator inclusive suspension bracket and stud to the floor stand
The top of the floor stand is screwed into the suspension bracket (Figure 5.10). The bracket is
supplied with both metric and Whitworth threaded plates, and is therefore compatible with
most standard floor stands. For floor stands, the mounting angle can be set at 0°, 15° or 30°.
5.4.3

Wall mounting

For wall mounting, an extra wall bracket (LBB 3414/00) is required (must be ordered
separately). This bracket is attached to the wall by means of four bolts (see Figure 5.12).
Figure 5.12 Attaching the wall mounting bracket to a wall
NOTICE!
The four bolts used to attach the bracket must each be able to withstand a pull-out force of
200 kg (440 lb). The bolts and plugs delivered with the LBB 3414/00 wall bracket are only
intended for mounting the unit on a solid brick or concrete wall.
Four holes of 10 mm in diameter and 60 mm in depth must be drilled using the drilling pattern
(see Figure 5.13).
Bosch Security Systems B.V. Installation and Operation manual
Installation | en 35
IOM-INT | V1.1 | 2010.12