Optional I/O Modules (Type C/ Hdmi/Vga/Dp/Serial); Removing Optional I/O Modules (Type C/ Hdmi/Vga/Dp/Serial) - Dell OptiPlex 5080 Service Manual

Steps
1. Insert the intrusion switch into its slot and slide the switch to secure it into the slot.
2. Connect the intruder cable to the connector on the system board.
Next steps
1. Install the fan duct.
2. Install the side cover.
3. Follow the procedure in

Optional I/O modules (Type C/ HDMI/VGA/DP/Serial)

Removing optional I/O modules (Type C/ HDMI/VGA/DP/Serial)

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the fan duct.
About this task
The following images indicate the location of the optional I/O Modules and provides a visual representation of the removal
procedure.
Steps
1. Remove the two (M3X3) screws that secure the optional i/O module to the computer chassis.
2. Disconnect the I/O-module cable from the connector on the system board.
after working inside your
before working inside your
computer.
computer.
Disassembly and reassembly 59