Advertisement
fig.4
5.5.
Check the connections of the safety thermostat and of the thermocouple: they must always be clean.
5.6.
If necessary clean the fan blade and the inside of the heater using compressed air.
WARNING: AIR CONTAMINANTS
‰
Air contaminants taken into the heater will damage the unit, cause health problems and safety issues.
For example: Body shop filler dust and overspray dust will clog the burner diffuser, contaminate the combustion chamber and
damage the internal parts of the heater. If contaminants are present the heater must be supplied with ducted clean air.
Please note that any parts damaged by filler dust or overspray dust will not be covered by warranty. Additionally a cleaning
charge will be made for any heaters damaged by filler dust or overspray dust.
6. TROUBLESHOOTING
Problem
Motor does not work
Motor works but the burner
does not light up and after a
few seconds the heater stops
The burner lights up but after a
few seconds the heater stops
The heater stops during
operation
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
Causes
No electrical supply
The gas cylinder tap is closed
The gas cylinder is empty
The nozzle is obstructed
The solenoid gas valve is not
open
There is no spark
Defective connection between
sensor and safety device
Defective safety device
Insufficient air flow
Insufficient gas supply due to
ice formation on the cylinder
sales@sealey.co.uk
Original Language Version
Solution
Check terminal board with a
tester
Open the gas tap
Use a new cylinder
Remove the nozzle and clean
it
Check that the solenoid valve
works
Check the position of the
electrode
Check and connect properly
Replace the safety device
Check that the motor works
properly
Check and use a larger
cylinder or two cylinders
connected together
www.sealey.co.uk
LP100.V7
REGISTER YOUR
PURCHASE HERE
Issue 3 (H,2,3) 19/04/23
Advertisement
