Table of Contents
Advertisement
(C) VERTICAL EXHAUST: Outside Ventilation
1. Remove and save 2 screws from back edge and 1 screw from the top center of the Fan Cover Bracket.
Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket
as shown in Figure 9 on page 5.
2. Withdraw Hood Fan Unit carefully and slip wires out of Wire Box. See Figure 10 on page 5.
CAUTION: Do not pull or stretch hood fan wiring.
3. Turn the Hood Fan Unit end-over-end. Rotate the Hood Fan Unit 90 degrees so that the fan blade open-
ings are facing upward. Replace Hood Fan Unit into the oven. Be
careful not to pinch the lead wire between the inner bracket and the
Hood Fan Unit. See Figure 14.
4. Put the lead wire into Wire Box. See Figure 14.
5. Replace the Fan Cover Bracket by sliding it into the slits in the same
direction as the arrow on the Fan Cover Bracket. Make sure the fan
blades are visible through the top openings in the oven before pro-
ceeding. Attach the Fan Cover Bracket to unit with 3 screws, which
were removed in Step 1 above. See Figure 12 on page 5. The Hood
Fan Unit is now rotated for vertical exhaust operation.
6. Attach the Exhaust Damper Assembly 8 to the fan cover on the top
of the outercase cabinet after mounting the oven. To attach the
Exhaust Damper Assembly, refer to MOUNTING OVEN TO THE
WALL, Step 7 on page 7.
9 OVEN INSTALLATION
THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUC-
TIONS FOUND ON BOTH TEMPLATES.
THE NEXT STEP IS TO READ AND FOLLOW MOUNTING INFORMATION ON BOTH TOP CABINET AND
WALL TEMPLATES.
NOTE: THIS OVEN SHOULD BE ATTACHED TO AT LEAST ONE WALL STUD. See WALL CONSTRUC-
TION on page 2.
MOUNTING PLATE
1. Separate 4 Toggle Bolts 2, packed in the INSTALLATION HARDWARE, from the Toggle Nuts.
2. Use Wood Screws 1 to attach Mounting Plate to the stud or studs. Use Toggle Bolts to attach Mounting
Plate through the holes at A, B, C and D; UNLESS THOSE HOLES ARE LOCATED ON THE STUD. Insert
one Toggle Bolt into A, B, C and D where appropriate (these correspond to the holes of the Wall Template)
and put the Toggle Nuts onto the Toggle Bolts. Figure 15.
Refer to instructions in Wall Template.
3. Position the Mounting Plate with the Toggle Bolts attached at the wall location and insert Toggle Nuts and
Bolts through the holes in the wall with the Toggle Nuts closed. Figure 16. Use Wood Screws 1 to attach
the Mounting Plate to studs.
NOTE: Before insertion, be sure you leave a space more than the thickness of the wall between the Mounting
Plate and the end of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the
Toggle Nut will not be able to open on the other side of the wall. Also, once a Toggle Nut opens, it cannot be
withdrawn from the hole; therefore make sure all of the Toggles are in the correct position before insertion.
4. Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts. Pull Toggle Bolt toward
you and turn clockwise to tighten. Figure 17.
Mounting
Plate
Figure 15
Space More Than
Wall Thickness
Figure 16
Wall
6
Figure 14
Figure 17
Advertisement
Table of Contents
