Using Multiples Handsets; Registering Handsets - Siemens Gigaset A580 User Manual

Using multiples handsets

Registering handsets

You can register up to six handsets to your base station.
When you register a new Gigaset handset, the base station transfers the
Gigaset.net entry for the Gigaset.net directory (
tory to enable you to use the Gigaset.net directory on your new handset.
Prerequisite: The handset can send and receive directory entries. See the
handset's user guide for further information.
Successful registration is acknowledged with the message
for this reason.
rec
Please note
u
If several handsets are registered on your base station, you can simultane-
ously make two calls via the Internet and one via the fixed line network.
Up to two additional internal connections are also possible.
u
Selecting the connection via the Talk key (
GAP handsets. This means that if you enter a number without a line suffix
and without defining a dialing plan for the phone number it will be dialed
via the default connection (
u
After registration, all the phone numbers for the phone will be assigned to
the handset as receive numbers. It will use the fixed line network number
and the first VoIP number in the configuration as send numbers.
For information on changing the assignments,
Registering another Gigaset A58H handset on the Gigaset A580 IP
Before you can use your handset, you must register it to the base station.
You must initiate handset registration on the handset and on the base station.
The handset will return to idle status if registration was successful. The hand-
set's internal name is shown in the display, e.g.
repeat the procedure. Registration can take up to one minute.
¤
On the handset: Select
press
¤
Enter the system PIN of the base station (the default is 0000) and press
Handset is registering
¤
Within the next 60 seconds press and hold (for approx. 3 seconds) the
Registration/Paging key (
The handset is assigned the lowest available internal number (1-6). The inter-
nal number appears in the display after registration, e.g.
the internal number 2 has been assigned to the handset.
§Menu§
.
§OK§
flashes on the display.
£
£
£
Page
£
Page 86).
INT
¢ ¢
Settings Handset
Page 2) on the base station.
Using multiples handsets
Page 48) to its local direc-
Data Transfer x entries
38) is not supported on
£
Page 120.
1. If it does not appear,
¢
Register Handset
2. This means that
INT
and
.
§OK§
71