Recommended Maintenance Schedule(S); Adjusting The Rotor Control Cable - Toro 260010001 Operator's Manual

•
If the snowthrower does not propel itself forward on
slippery surfaces or in heavy snow, push forward on
the handle, but allow the snowthrower to work at its
own pace.
•
Overlap each swath to ensure complete snow removal.
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the rst operating
hour
Yearly
Yearly or before storage
Adjusting the Rotor Control
Cable
Checking the Rotor Control Cable
Check the rotor control cable for proper adjustment initially,
after the first operating hour, and then annually thereafter.
1. Move the control bar back toward the handle until you
remove the slack in the cable (Figure 20).
Figure 20
2. Ensure that a 1/8 to 1/4 inch (3 to 6 mm) gap exists
between the control bar bracket and the handle (Figure
21).
Maintenance Procedure
• Check the rotor control cable and the traction drive cable both initially and after
the rst hour of operation; adjust them if necessary.
• Check for loose fasteners and tighten them if necessary.
• Check the rotor control cable and the traction drive cable and adjust them if
necessary.
• Inspect the rotor blades and have an Authorized Service Dealer replace the rotor
blades and the scraper if necessary.
• Have an Authorized Service Dealer inspect the spark plug and replace it if
necessary.
• Have an Authorized Service Dealer inspect the drive belt and replace it if necessary.
• Check for loose fasteners and tighten them if necessary.
• Prepare the snowthrower for storage.
•
Discharge the snow downwind whenever possible.
•
In snowy and cold conditions, some controls and
moving parts may freeze. Do not use excessive force
when trying to operate frozen controls. If you have
difficulty operating any control or part, start the engine
and let it run for a few minutes.
Figure 21
1. 1/8 to 1/4 inch (3 to 6 mm)
2. Control bar bracket
Important: The rotor control cable must have
slack in it when you disengage the control bar in
order for the rotor blades to stop properly.

Adjusting the Rotor Control Cable

1. Unhook the spring end from the control bar bracket.
(Figure 22).
10