Useful Features Of The Xdk Workbench; Showing Line Numbers; Enabling Autosave Before Building A Project; Adding A New Interface - Bosch XDK110 Quick Start Manual

!

4. Useful features of the XDK Workbench

4.1 Showing Line Numbers

This section describes how to set useful configurations in the XDK Workbench. First, you should enable
autosaving before building. The following screenshot shows where the configuration can be found in Window
> Preferences and which checkbox has to be selected.
Picture 20: Line Numbers

4.2 Enabling autosave before building a project

Another useful setting is autosaving before flashing. This feature is especially helpful if there are small
changes in the code done and not saved before the project was flashed to the XDK. Sometimes it can
happen that code that was not saved is flashed to the XDK and it runs for example a non-functional
application on the XDK besides working code. The following screenshot describes where autosaving can be
enabled found in Window > Preferences.
Picture 21: Enabling autosave
!

4.3 Adding a new Interface

This section describes how to add new interfaces to an existing application in the XdkApplicationTemplate or
in other projects.
There are two ways to add new source and header files to an existing project. Import existing files into the
project or create a new one. Existing files can be placed in the project folder and simply imported in the XDK
XDK110
© Bosch Connected Devices and Solutions GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as
copying and passing on to third parties. BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany.
Note: Specifications within this document are subject to change without notice.
Workbench First Steps Guide XDK110
!
Page ! 2 1
BCDS