Table of Contents
Advertisement
4
Installing the Wire Harness
and Throttle Cable
Parts needed for this procedure:
4
Cable ties
1
Throttle cable
Procedure
1.
Install the wire harness to the interlock connector
on the wire harness bracket and clip the wire
harness to the bracket.
1. Wire harness connectors
2. Install the wire harness
clip here.
2.
Mount the green ground wire using the cowling
bolt under the fuel tank, and connect the red wire
to the engine connector as shown in
Note:
Apply skin-over grease to the bolt and
ground lug terminal.
Figure 6
3. Interlock connector
Figure
1. Cowling bolt
2. Ground wire
3. Disconnect this wire from
the engine connector.
3.
Route the harness up the left side of the handle
(Figure
8).
4.
Connect the engine switch to the wire harness
(Figure
8).
g274613
Note:
Connect the wire harness to the
hourmeter (if equipped).
5.
Secure the wire harness under the console
cover with a snap clip and cable ties as needed.
6.
If the machine has a light kit, use the wire
harness adapter to install the main wire harness
to the engine.
7.
7.
Attach the cables and wire harness to the
handles using the 4 new cable-ties
6
Figure 7
4. Engine connector
5. Install this wire harness
connector to the engine
connector.
(Figure
g274609
8).
Advertisement
Table of Contents
