Table of Contents
Advertisement
44
en | Recording
7
Recording
7.1
Introduction to Recording
Images can be recorded to an appropriately configured iSCSI system or directly to local
memory storage media inside the camera.
For shorter storage times and temporary recordings, the local memory media inside the
camera is the ideal solution. It can be used for local alarm recording or to improve the overall
reliability of video recording. For long-term, authoritative images, use an appropriately sized
iSCSI system.
Two recording tracks are available (Recording 1 and Recording 2). The encoder streams and
profiles can be selected for each of these tracks for both standard and alarm recordings. Ten
recording profiles are available where these recording tracks can be defined differently. These
profiles are then used for building schedules.
A Video Recording Manager (VRM) can control all recording when accessing an iSCSI system.
The VRM is an external program for configuring recording tasks for video servers.
7.2
Storage Management
7.2.1
Device manager
An external Video Recording Manager (VRM) system for the unit is configured via the
Configuration Manager. The Managed by Video Recording Manager software box is only an
indicator; it cannot be changed here.
If the Managed by Video Recording Manager software box is checked, you are not able to
configure any further recording settings on this page.
7.2.2
Recording media
Select a media tab to connect to the available storage media.
iSCSI Media
To use an iSCSI system as the storage medium, a connection to the desired iSCSI system is
required to set the configuration parameters.
The storage system selected must be available on the network and completely set up. It must
have an IP address and be divided into logical drives (LUNs).
1.
2.
3.
The Storage overview field displays the logical drives.
Local Media
Embedded local storage memory in the camera can be used for local recording.
- To use the embedded local storage memory for Automatic Network Replenishment (ANR),
select the check box.
- If embedded local storage memory is password-protected, enter the password into the
Password field.
The Storage overview field displays the local media.
Note: For more information about Automatic Network Replenishment (ANR), refer to the White
Paper "ANR 2.0 Automatic Network Replenishment (ANR)," available on the product page for
your camera. Access the product page on the online product catalog from http://
www.boschsecurity.com/corporate/product-catalog/index.html.
2017.11 | 0.20 | F.01U.349.011
Enter the IP address of the required iSCSI destination in the iSCSI IP address field.
If the iSCSI destination is password protected, enter the password into the Password
field.
Click Read.
–
The connection to the IP address is established.
User Manual
MIC IP fusion 9000i
Bosch Security Systems
Advertisement
Table of Contents
