Changing The Hydraulic Oil And Filter - Toro Groundsmaster 360 Operator's Manual

1. Dipstick
Changing the Hydraulic Oil
And Filter
Service Interval: After the first 200 hours
Every 800 hours
1. Disengage the PTO, release the traction pedal
to the neutral position and set the parking brake.
2. Move the throttle lever to the Slow position,
stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Place a large pan under the hydraulic reservoir
and transmission case and remove the plugs,
draining all of the hydraulic fluid
Figure 66
(Figure
g014190
1. Transmission case drain
plug
2. Filter
4. Clean the area around the hydraulic oil filter and
remove it
5. Immediately install a new hydraulic oil filter.
6. Install the hydraulic reservoir and transmission
case drain plugs.
7. Fill the reservoir to the proper level
(approximately 17 liters [18 quarts]); refer to
67).
Checking the Hydraulic Fluid.
8. Start the engine and check for oil leaks. Allow
the engine to run for about five minutes, then
shut it off.
9. After two minutes, check the level of the
hydraulic fluid; refer to Checking the Hydraulic
Fluid.
55
Figure 67
3. Hydraulic reservoir drain
plug
(Figure 67).
g014393