Advertisement
out
Opening the detector
Damage to the connection cable
In order to prevent damage to the connection cable when positioning the housing cover,
make sure that the connection cable has been routed correctly.
The service area for the detector can be accessed in two ways.
●
●
4
Smart Infrastructure
Blowing
Error
CAUTION
Partial access:
– Remove the two screws on the top of the detector.
– Slide the housing cover up until you hear it snap into place.
Full access:
– Remove the two screws on the top of the detector.
– Slide the housing cover up until you hear it snap into place.
– Pull the housing cover out slightly at the sides and lift it up.
– Remove the housing cover.
1
High flow
Normal flow
Low flow
2
Fire 2
Fire 1
Pre-alarm
A6V10331032_k_en_--
No smoke
Fault/test
Dust
2021-06-28
Advertisement
