Installation Instructions Infrared Remote Controller CZ-RWS3 Model No. English Read through the Installation Instructions before you proceed with the installation. In particular, you will need to read under the “Safety Precautions” on page 2. Contents Safety Precautions ........2 Supplied accessories ........4 Specifi...
Read before installation This controller must be installed by the sales dealer or installer. These instructions are all you need for most installation sites and maintenance conditions. If you require help for a special problem, contact our sales/service outlet or your certifi ed dealer for additional instructions.
Page 3
Do not wash with water. CAUTION Do not operate with wet hands. Do not allow infants and small Do not drop or throw. (It may children to prevent them from cause malfunction.) accidentally swallowing the ...
Operating Instructions <1> Installation Instructions <1> Instructions Disc <1> Specifi cations CZ-RWS3 Model No. Dimensions (H) 165 mm × (W) 59 mm × (D) 22 mm Weight 100 g (Batteries and remote control holder are not included) Temperature/Humidity 0 ˚C to 40 ˚C / 20 % to 80 % (no condensation)
Installation Precautions The controller uses a very weak infrared light for its signal, which can result in the signal not being received because of the following infl uences, so take care in where the indoor unit is installed. • Inverter or rapid-start type fl uorescent lights (Models without glow lamps) •...
Before Starting Install this controller referring to the “Operating Instructions”. (1) Insert the batteries. (Installing Batteries) (2) Set the current time. (Setting the Current Time) (3) Install the remote control holder. (Using the Remote Controller) (4) Perform the pairing address setting, if required. (Paring Addresses) When using the wall mounted type indoor unit Note...
Miscellaneous Settings • These settings are saved in nonvolatile memory in the remote controller, so even when its batteries are changed, the settings do not have to be made again. • Furthermore, making changes to these settings may cause actual operation to deviate from what is printed in the Operating Instructions, so be sure to fully explain this to the customer.
Auto Address Set the Auto Address for each O/D unit no. (outdoor Address unit number) Select the O/D unit no. for Auto Address. 1. Press for 4 seconds or longer. • " " starts blinking and the setting screen is displayed.