Connections (Notifications); Other Connections; Antenna Connection - LG 98UH98 Series Owner's Manual

Connections (notifications)

Connect various external devices to the TV and switch input modes to
select an external device. For more information of external device's
connection, refer to the manual provided with each device.
Available external devices are: HD receivers, DVD players, VCRs, audio
systems, USB storage devices, PC, gaming devices, and other external
devices.
NOTE
• The external device connection may differ from the model.
• Connect external devices to the TV regardless of the order of the
TV port.
• If you record a TV program on a DVD recorder or VCR, make sure to
connect the TV signal input cable to the TV through a DVD recorder
or VCR. For more information of recording, refer to the manual
provided with the connected device.
• Refer to the external equipment's manual for operating
instructions.
• If you connect a gaming device to the TV, use the cable supplied
with the gaming device.
• In PC mode, there may be noise associated with the resolution,
vertical pattern, contrast or brightness. If noise is present, change
the PC output to another resolution, change the refresh rate to
another rate or adjust the brightness and contrast on the PICTURE
menu until the picture is clear.
• In PC mode, some resolution settings may not work properly
depending on the graphics card.
• Some USB Hubs may not work. If a USB device connected using
a USB Hub is not detected, connect it to the USB port on the TV
directly.
• If Ultra HD content is played on your PC, video or audio may
become disrupted intermittently depending on your PC's
performance.

Antenna connection

Connect the TV to a wall antenna socket with an RF cable (75 Ω).
• Use a signal splitter to use more than 2 TVs.
• If the image quality is poor, install a signal amplifier properly to
improve the image quality.
• If the image quality is poor with an antenna connected, try to
realign the antenna in the correct direction.
• An antenna cable and converter are not supplied.
• Supported DTV Audio: MPEG, Dolby Digital, Dolby Digital Plus,
HE-AAC
• This TV cannot receive ULTRA HD (3840 x 2160 pixels) broadcasts
directly because the related standards have not been confirmed.

Other connections

Connect your TV to external devices. For the best picture and audio
quality, connect the external device and the TV with the HDMI cable.
Some separate cable is not provided.
NOTE
→ → → General → HDMI ULTRA HD Deep
•
Colour
- On: Support 4K @ 50/60 Hz (4:4:4, 4:2:2, 4:2:0)
- Off: Support 4K @ 50/60 Hz 8bit (4:2:0)
• If the device connected to Input Port also supports ULTRA HD Deep
Colour, your picture may be clearer. However, if the device doesn't
support it, it may not work properly. In that case, connect the
device to a different HDMI port or change the TV's ULTRA HD Deep
Colour setting to Off.
- This feature is available on certain models which are supported
ULTRA HD Deep Colour only.
• Supported HDMI Audio format : Dolby Digital (32 kHz, 44.1 kHz,
48 kHz), DTS (44.1 kHz, 48 kHz), PCM (32 kHz, 44.1 kHz,48 kHz,96
kHz,192 kHz) (Depending on model)
Remote control
(Depending on model)
The descriptions in this manual are based on the buttons on the
remote control. Please read this manual carefully and use the
TV correctly. To replace batteries, open the battery cover, replace
batteries (1.5 V AAA) matching the
inside the compartment, and close the battery cover. To remove the
batteries, perform the installation actions in reverse.
CAUTION
• In Analogue TV and some countries, some remote control buttons
may not work.
Make sure to point the remote control toward the remote control
sensor on the TV.
and ends to the label
11