Table of Contents
Advertisement
Starting or interrupting operation
To start operation or to interrupt an operation which has
started running, press the Start/Stop button. The
cooling fan may continue to run after an operation is
interrupted.
Press the On/Off button to delete all settings.
If you open the cooking compartment door during
operation, operation is interrupted. Close the cooking
compartment door to continue operation.
Filling the water tank
When you open the appliance door, you will see the
water tank on the right-hand side. Before starting the
operation, fill the water tank with water.
Ensure that you have correctly set the water hardness
range. ~ "Basic settings" on page 18
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Fill the water tank before each use:
Open the appliance door.
1.
Remove the water tank from the water tank recess
2.
(picture
).
!
Fill the water tank with cold water up to the "max."
3.
mark. (Picture
).
"
Close the tank cover
4.
until you feel it engage.
Insert the filled water tank (picture
5.
Check whether the water tank is pushed in flush with
6.
the water tank recess (picture
Close the appliance
7.
door.
The water tank has been filled. You can now start the
operation.
).
#
).
$
Refilling the water tank
If the water tank is empty, the prompt to fill the water
tank appears on the display. The operation is stopped.
:
Warning – Risk of scalding!
When you open the appliance door, hot water may flow
out of the appliance. When opening the door, do not
stand too close to the appliance. Open the appliance
door carefully. Keep children away from the appliance.
If the evaporator dish overflows, do not pour more water
into the water tank.
Carefully open the appliance door.
1.
Remove the water tank and fill it.
2.
Slide the water tank back in and close the appliance
3.
door.
Start the operation.
4.
The operation continues.
Setting the type of heating and temperature
After the appliance is switched on, the suggested type
of heating appears with the temperature. You can start
this setting immediately with the Start/Stop button.
For other settings, you can change the values as shown
in the pictures.
Example: 15 minutes steaming at 90 °C
Use the rotary selector to change the type of
1.
heating.
Press the arrow ¿ to switch to the temperature.
2.
Use the rotary selector to change the temperature.
3.
Use the 0 button to switch to the cooking time.
4.
Use the rotary selector to change the cooking time.
5.
Press the Start/Stop button.
6.
The set type of heating, temperature and cooking time
are shown in the display.
Operating the appliance
en
13
Advertisement
Table of Contents
