Table of Contents
Advertisement
7 Electrical connection
The electrical installation may only be performed by qualified personnel.
Electrical connection of the appliance must be done in accordance with electrical safety regulations.
We recommend that the mains cable be equipped with a ground fault interrupter.
The manufacturer disclaims all liability if the electrical connection is not done in the manner prescribed in this
manual.
Electrical connections
Heating alternative
Machines with heat pump
1.
Total power and recommended fuse does not depend on the heating power in those cases.
Connection to the mains must be via an all-pole switch.
Connection is only permitted to a mains with maximum impedance of 0.239 ohm.
• Remove the front plate. The front plate is secured with four screws at the top and four screws at the bottom.
• Install a 5-wire connecting cable to the terminal block on the PCB as indicated in the wiring diagram. Route the ca-
ble to and through the marked bushing in the roof plate.
• Thread the door cable through the hole (see figure) and connect as indicated in the wiring diagram.
• Reinstall the front plate.
1
Bushing in roof plate for feed cable
2
Circuit board
3
Terminal block
4
Thread the door cable through the hole
5
Door cable
6
Front plate
7.1 Network Functions
Note!
Can only be used on premium products.
This product can be connected to ELS VISION or to an external payment system.
Installation manual
Main voltage
400V 3N~
6
5
Hz
Heating power
kW
1
50
1
2
3
4
Total power
Recommended
fuse
kW
A
2.3
10
fig.W01377
29
Advertisement
Table of Contents
