Problems That Can Be Resolved Before Calling The Service Centre - Whirlpool ACE 100 IX Instructions For Use Manual

MESSAGE
INSERT INFUSER ASSEMBLY
GENERIC ALARM

15 PROBLEMS THAT CAN BE RESOLVED BEFORE CALLING THE SERVICE CENTRE

If the appliance is not working, the causes of the malfunction can be identified and resolved by referring to
chapter 14. If, on the other hand, no message is displayed, run the following checks before calling the ser-
vice
PROBLEM
The coffee is not hot
The coffee is not creamy
enough
The coffee runs out too
slowly.
The coffee runs out too
quickly.
The coffee does not come
out of one of the spouts.
When the steam button is
pressed, no steam comes out
of the cappuccino maker
When the ,
, button is pressed, the
appliance does not deli-
ver coffee, but only water.
38
• After cleaning, the infuser has probably
been left out of the coffee maker.
• The inside of the appliance is very dirty. •
CAUSE
• The cups have not been preheated.
• The infuser is too cold
• The coffee is ground too coarsely
• Wrong type of coffee
• The coffee is ground too finely.
• The coffee is ground too coarsely.
• The spout holes are blocked.
• The holes in the cappuccino maker and
steam nozzle are clogged.
• The ground coffee may be blocked in
or
the funnel..
MEANING
• Heat the cups by rinsing them in hot water (see note 3,
chapter 5).
• Heat the infuser by pressing the
making the coffee (fig. 11, see note 3, chapter 5).
• Turn the grinding regulator one click anticlockwise (see
chapter 7).
• Use a type of coffee for espresso coffee makers.
• Turn the grinding regulator one click anticlockwise (see
chapter 7).
• Turn the grinding regulator one click anticlockwise (see
chapter 7).
• Scrape off the dry coffee residues with a needle (fig. 23).
• Clean the holes in the cappuccino maker and the steam
nozzle (see chapter 10 - fig. 22).
• Remove the ground coffee inside the funnel using a knife
(see chapter 8 - note 5). Then clean the infuser and the
inside of the appliance (see description in chapter 11.2)
WHAT TO DO
• Insert the infuser, see chapter 11.2
Thoroughly clean the inside of the
appliance, as described in chapter
11.2. If the message is still displayed
after cleaning, contact a service centre.
SOLUTION
button before