Changing The Language; Meaning Of Messages And What To Do - Whirlpool ACE 100 IX Instructions For Use Manual

13 CHANGING THE LANGUAGE

To change the language, proceed as follows:
• Press the
and press the
sage in English.

14 MEANING OF MESSAGES AND WHAT TO DO

MESSAGE
FILL TANK
GROUND TOO FINE
ADJUST MILL AND
Press the OK button
EMPTY GROUNDS CONTAINER
INSERT GROUNDS CONTAINER
ADD PRE-GROUND COFFEE
FILL BEAN CONTAINER
DESCALE
PRESS NEXT+ CHANGE
CLOSE DOOR
button for at least 5 seconds until the appliance displays:
PRESS OK TO INSTALL ENGLISH
button for at least 3 seconds to confirm. The appliance then displays the setting mes-
• The water tank is empty or is positioned
incorrectly.
• The tank is dirty or encrusted with lime
scale.
• The coffee runs off too slowly.
• The appliance cannot make coffee
• The grounds container is full
• After cleaning, the grounds container
has not been replaced.
• With the ground coffee function selec-
ted, ground coffee has not been poured
into the funnel
• The coffee beans have run out.
• If the coffee grinder is very noisy, this
means a small stone in the coffee beans
has blocked the mill.
• This indicates the presence of lime scale
in the appliance.
• After cleaning, the infuser has probably
been left out of the coffee maker
• The service door is open.
MEANING WHAT TO DO
• Fill the water tank as described in chap-
ter 5, note 6 and insert it fully.
• Rinse or descale the tank.
• Turn the grinding regulator (fig. 10) one
click clockwise (see chapter 7).
• Press the OK button (fig. 17).
• Empty the grounds container and clean
as described in chapter 5, note 7, then
replace.
• Open the service door and insert the
grounds container.
• Add the ground coffee as described in
chapter 8.
• Fill bean container
• Contact an authorised service centre.
• The descaling procedure, described in
chapter 12.3, needs to be performed as
soon as possible.
• Leave the service door closed and the
infuser out of the appliance, then follow
the instructions displayed.
• If the service door cannot be closed,
check that the infuser is inserted cor-
rectly (chapter 11.2 - note 1)
37