Craftsman 240.74295 Operator's Manual page 5

3.Charge f oratleast 1 hour.
4.The LED will g low redwhen the
battery i scharging andgreen w hen
itisready t ouse. I ftheLED does not
illuminate when thehandle i splaced in
thecharge r ack, c heck t omake sure
thatthere isproper contact between
thehandle a nd thecharger base.
5.Asecond c harging bayisprovided
onthecharge r ack tocharge a second
battery ( not i ncluded). Tocharge a
battery i nthisbay, i nsert t hebattery
until i tlocks inplace and theLED
illuminates. (see figure 2)TheLED
will g low redwhen thebattery i s
charging andgreen w hen itisready
touse. W hen charging twobatteries
(one inthehandle a nd onedirectly i n
thecharger), thecharger willcharge
whichever battery w asinserted
first. T hen when thatbattery i sfully
charged, itwill a utomatically switch
andcharge t heother b attery. Each
battery w ilttake approximately 1hour
tocharge ( atotal o f2 hours f ortwo
batteries).
thecharge t oeach battery a nd shuts
ofthecharge w hen complete. The
batteries canbeleftinthecharger
indefinitely and will n otover-charge.
Longest lifeandbest p erformance wilt
beobtained when charging atnormal
room temperature.
Battery l ifeisdependent onusage,
storage t emperature andtime.
CONNECTING
TOOL ATTACHMENT
TO THE POWER HANDLE
Be sure to follow the following
safety precautions when attaching
and detaching tools from the power
handle.
Remove the battery from the handle
before attaching or detaching tools.
Never touch the control switches on
the power handle when attaching and
detaching tools
To attach a toot:
1. Twist the lock ring on the power
handle to the unlocked position. (see
figure 3)
Figure 2
Charging Notes:
CAUTION: The charger can only
be used with 60 cycle, 115-120 VAC
electricity.
The charger unit plugged into the AC
outlet wilt normally become warm to
the touch during charging.
The charger automatically controls
Figure 3
2. Insert the male end of the power
handle interface into the female socket
in the end of the tool attachment
making sure that it is firmly seated.
(see figure 4) The interface is keyed
so that it will only go together one
way. The handle and tool should go
together easily. If you experience
resistance in putting them together,