Toro 08761 Operator's Manual page 5

Inspecting and Cleaning
the Nail Drag
When the scarifying operation is completed, clean
the machine thoroughly. Since this machine is used
primarily in extremely abrasive conditions, the material
should be flushed off after each use. If the machine
is cleaned frequently, it can be cleaned with a stream
of water from a hose with the nozzle removed. A high
pressure stream could drive the sand into wear areas
where it could act as a grinding compound.
Note:
If the attachment adapter becomes stuck to
the traction unit adapter, insert a prybar/screwdriver
into the pry slot to disengage the parts.
g003783
Figure 6
1. Pry slot
5