D-Link DIR-615 User Manual page 147

DIR-615 Wireless N300 Router
User Manual
The following elements are available on the page:
Parameter
IGMP
Set the address of
outgoing IGMP packets
equal to 0.0.0.0
SIP
RTSP
PPPoE pass through
IPsec pass through
L2TP pass through
PPTP pass through
After specifying the needed parameters, click the APPLY button.
3 On the Connections Setup / WAN page, create a WAN connection, move the SIP switch to the right on the
Advanced / IGMP/ALG/Passthrough page, connect the phone cable between a LAN port of the router and the
IP phone. Specify SIP parameters on the IP phone and configure it to obtain an IP address automatically (as DHCP
client).
Select a version of IGMP from the drop-down list. Such a setting
allows to enable multicasting from the WAN connection selected in
the IGMP section on the Connections Setup / WAN page.
Move the switch to the right if you want all outgoing IGMP packets
to have the IP address 0.0.0.0.
Move the switch to the right to enable SIP. Such a setting allows
using the SIP ALG function. This function allows VoIP traffic to
pass through the NAT-enabled router.
Move the switch to the right to enable RTSP. Such a setting allows
managing media stream: fast forward streaming audio/video, pause
and start it.
Move the switch to the right
function.
Move the switch to the right
function.
Move the switch to the right
function.
Move the switch to the right
function.
Page 147 of 184
Configuring via Web-based Interface
Description
3
to enable the PPPoE pass through
to enable the IPsec pass through
to enable the L2TP pass through
to enable the PPTP pass through