Disposal; Disposal Of Refrigerant - Silvercrest SLE 320 A2 Operating Instructions Manual

Fault Possible cause
The air inlet or air outlet aperture
is soiled or obstructed.
The appliance
is producing The room's windows and doors
no or limited are open.
condensate.
Is the appliance running in the
AIR CLEAN programme? Dehu-
midification is not taking place.
Water is The appliance was overly agitated
pooling on the during positioning. There is re-
floor. sidual water in the appliance.
The air ejected
Heat exchange process
is warm.
The error code
E 1 is flashing
Coil temperature error
on the display.
The error code
E 2 is flashing
The humidity sensor is defective.
on the display.
NOTE
► If you are unable to resolve the problem applying any of the aforementioned
methods, please contact the Customer Service department
(see the chapter Service).

Disposal

Under no circumstances should you dispose of the appliance in
normal household waste. This product is subject to the provisions
of the European WEEE (Waste Electrical and Electronic Equipment)
Directive 2012/19/EU.
Dispose of the appliance via an approved waste disposal company or your
municipal waste disposal facility. Please observe applicable regulations.
Please contact your waste disposal facility if you are in any doubt.

Disposal of refrigerant

This appliance contains refrigerant R134a and must be disposed of by profes-
sionals.
SLE 320 A2
Rectification
Ensure that the air inlet and air outlet
apertures are clean and free of
obstructions.
Close the windows and doors.
Select a different programme, such as
AUTOMATIC MODE.
This is a normal feature of the ap-
pliance. When re-positioning the
appliance, ensure that it is not overly
agitated.
This is a normal feature of the appli-
ance.
Contact the Customer Service depart-
ment.
Contact the Customer Service depart-
ment.
│
GB 21 ■