Auxiliary Power - Bosch DINION IP starlight 6000 HD Installation Manual

DINION IP starlight 6000
HD
6.2

Auxiliary power

Earth
Caution!
Use only a +12 VDC power supply for auxiliary power, and
!
check this supply complies with EN/UL 60950.
Caution!
Ensure the output from the power supply is isolated from earth.
!
The camera is originally supplied with a warning sticker over the
12VDC connections on the back of the camera (stating that only
a 12VDC power supply may be used). Always first peel off this
sticker before connecting power wires.
Connect an approved power supply unit with a rated supply
voltage of 12 VDC as follows:
1.
2.
3.
Bosch Security Systems
4 5 6 | 4 5 6
D A E
A L T
T A H
A R -
M P
o
1 2 3 | 1 2 3
E
- +
MENU
CVBS
! ! !
12VDC
only
Strip back 7 mm (0.28 in) of insulation on the power supply
cable; must be 14-30 AWG (stranded wire) or 16-28 AWG
(solid wire).
Loosen the screws of the supplied 2-pole connector and
insert the stripped wires, then tighten the screws again.
Insert the 2-pole connector into the camera power socket.
Connection | en
7 mm
2016.06 | v1.0 | AM18-Q0705
15