Remove The Edp Cable Brackets; Remove The Audio Board Cable - Lenovo ThinkBook Plus Gen 4 Hardware Maintenance Manual

Screw specifications
M2 × L2.8
Go to https://support.lenovo.com/partslookup
replacement part:
Fans

Remove the EDP cable brackets

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 26
Step 1. Disconnect the battery pack cable from the system board. Then, remove four screws and remove
the EDP cable brackets.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Figure 11. Disconnect the battery cable, remove four screws and the EDP cable brackets
Screw specifications
M1.6 × L2.9
Go to
https://support.lenovo.com/partslookup
replacement part:
EDP cable brackets

Remove the audio board cable

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 26
Number of screws
4
to look up the Lenovo part numbers of the following
Number of screws
4
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
33