Philips TAB8947 User Manual page 18

success, a sound will be heard from
the speaker.
4
After successful Wi-Fi connection,
the Wi-Fi light indicatar on the front
cabinet will stop pulsing and turn
solid. Once you set up this product
on your Wi-Fi network, you can
control it from any smartphone or
tablet on the same network.
5
After connection, you can change
the device name by Google Home
App. Otherwise, it follows the
default name.
6
If the ToU (Term of Use) is accepted,
after connection, this product
may perform a software update.
Upgrade to the latest software
when it is your first time set up.
The software upgrade may take
several minutes. Do not unplug
your speaker, turn off your device,
or leave the network during the
update.
AirPlay 2 setup
To stream using AirPlay 2, connect the
soundbar to the same network as the
Apple product.
1
On your iOS device, go to : Settings
> Wi-Fi > SET UP NEW AIRPLAY
SPEAKER [Philips TAB8947SB-
xxxx]
2
Select the speaker, add it to wifi
then go next steps as prompt.
» Keep the wifi AP (e.g. dlink655)
as same as the iOS device's.
» After successful Wi-Fi
connection, the Wi-Fi light
indicator on the front cabinet
will stop pulsing and turn solid.
Once you set up this product
on your Wi-Fi network, you
EN 18
can control it from supported
devices on the same network.
3
Launch a music app on your Apple
device, then play music.
4
Click the AirPlay icon
5
In the pop up list, select Philips
TAB8947SB-xxxx speaker. Wait a
moment music will be casted to
speaker.
Note
•
If the ToU (Term of Use) is accepted, after
connection, the product may perform a
software update. Upgrade is required after
initial set up. Without the upgrade, not all
product features can be available.
•
When the first time set up is not successful,
hold down the Wi-Fi button on soundbar for
8 seconds until the Wi-Fi light is changed
to slow pulse. Reset the Wi-Fi connection,
restart the app and start the set up again.
•
If you want to change from one network to
another, you need to set up the connection
again. Press hold down the
on the soundbar for 8 seconds to reset the
Wi-Fi connection.
WPS mode
If your router has Wi-Fi Protected Setup
(WPS), you can set up the connection
without entering a password.
1
Press and hold the Wi-Fi button for
5 seconds. The Wi-Fi light will begin
in double blink.
(Wi-Fi) button
WPS